fbpx

Construction industry loophole leaves home buyers facing higher energy bills

 

 

Home buyers across Australia could face higher energy bills because of a loophole that allows builders to sidestep energy efficiency requirements.

Since the early 2000s, all new homes built in Australia have to meet minimum thermal performance standards. In about 70% of cases, these homes are accredited using star ratings under the federal government’s Nationwide House Energy Rating Scheme (NatHERS). Most new houses have to meet a minimum 6-star rating. The higher the rating, the more energy-efficient the home.

Besides the star rating system, there are three other ways to meet the thermal efficiency standards, including one known as Verification Using a Reference Building (VURB), which awards a pass or fail rather than stars. It was designed to allow houses with alternative building techniques to comply with the standards.

But some builders are using this approach to accredit houses that fall well short of the 6-star standard under the NatHERS system – a tactic that is legal under the current system.

One consulting engineering firm, Structerre, which is active in Western Australia, Queensland, Victoria and New South Wales, has advertised that it has saved builders thousands by adopting the pass/fail approach under VURB. Structerre declined to comment for this article.

Double Storey Residential Building
A Structerre advertisement showing how a double storey residential building originally rated 4.5 stars using NatHERS and using the VURB pathway was able to meet energy compliance without adding cavity insulation or upgraded glazing.
Structerre

By using VURB, builders can forego installing items that would ordinarily be needed to gain a minimum 6-star rating, such as cavity insulation or upgraded glazing.

Upgrading a home from a 4.5-star rating to 6 stars can cost between A$2,000 and A$4,000 for a typical single-storey four-bedroom house. It is even more expensive for double-storey homes on narrow blocks with sub-optimal orientation.

Energy uncertainty

It is hard to say exactly how much higher energy bills would be in a home that falls below 6-star standard, because of the many other factors that influence bills. But major Australian house builder BGC Residential estimates that people with a 4-star or 5-star rated home could pay about 30% more than people living in a 6-star home.

A CSIRO study of more than 400 Australian houses built in the past 10 years found that higher-rated homes saved significantly on winter heating costs.

However, a study of 10 homes in Perth found significant variation in energy use between homes with the same rating.

The picture is complicated further by a phenomenon known as the takeback effect, in which some people in energy-efficient homes actually increase their energy consumption.

Misleading standards

Michael Bartier, executive general manager of BCG Residential, one of the first companies to adopt NatHERS 6-star rating as a standard building practice, said the use of loopholes could harm the industry’s reputation and cost buyers money.

“My concern is that there are a large number of homes built in the past 12-18 months that have not achieved the NatHERS 6-star rating, without the owners’ or customers’ knowledge. These homes could be rated as low as 2.7 stars and suffering poor thermal performance, costing the owners significantly more in heating and cooling energy costs and affecting final resale value,” he said.

While universal certificates are generated for homes found to comply with NatHERS, making them easier to track, it’s hard to tell how many homes have been signed off with VURB, as recording is not mandatory for those homes.

Some industry insiders are concerned that, without public scrutiny, the use of this loophole will increase.

A better picture

CSIRO, which owns the software used for NatHERS ratings, has developed a database of new homes’ energy ratings across Australia.

It currently has data for most homes built since May 2016, and is aiming to make its data available to the public. Some preliminary data are shown in the map below.


Average star rating for homes built since May 2016, in a selection of Australian climate zones. It does not show all homes, and in particular does not show homes that met compliance using the VURB pathway. Data courtesy of CSIRO.

Click on the zones to see the average star ratings.


There are more drawbacks besides the potential impact on energy bills. The National Construction Code states that home thermal efficiency standards are also important for reducing greenhouse gas emissions.

In 2013, Australia’s residential and commercial buildings were responsible for almost a quarter of the nation’s greenhouse emissions.

Several groups have warned about the use of the VURB pathway, including CSIRO, state governments, and the federal Department of the Environment and Energy. But it is unclear whether these warnings will catch the eye of home buyers.

The Australian Building Codes Board is reviewing the system (it is open for public comment until February 2018), and plans to “strengthen the technical provisions” in the 2019 version of the National Construction Code.


The ConversationThis article was amended on October 13, 2017. The correct cost of upgrading a typical single-storey four-bedroom home from 4.5 stars to 6 stars is between A$2,000 and A$4,000, not tens of thousands of dollars as previously stated.

Saskia Pickles, PhD candidate, Curtin University

This article was originally published on The Conversation. Read the original article.

 

Take our Solar Quiz Compare Energy Providers and Save

Download Your FREE Ultimate Guide to Solar Power in Australia - 2021 Edition

Beginners Guide to Solar Power

If you’re considering solar for your property or just looking to maximise the savings for your solar system, download a FREE copy of our "Ultimate Guide to Solar Power in Australia - 2021 Edition".

Become an expert and better understand the ins and outs of solar power and solar PV systems for your property.

Includes detailed explanations and diagrams of the various types of solar systems and their parts, solar battery storage systems, Government incentives, expected ROI periods, finance, energy-saving tips and more!

Download Your Free Copy Now!

Latest blog & information

X

Please provide your email address so that we can send your free copy of "The Ultimate Guide to Solar Power in Australia - 2021 Edition".

* By clicking "Send me a copy" I agree to the terms in TQC’s privacy policy.

Thank you

A link to download your copy of "The Ultimate Guide to Solar Power in Australia - 2021 Edition" has been emailed to the address you provided.

If this message does not appear in your inbox, ensure that you have provided the correct email address or check your junk/spam folder.

This message will close in 10 seconds or

Close and back to page
X

Understanding Batteries

Off-Grid Systems

For some households a battery system can be of great benefit and minimise a home’s reliance on the grid. However, it’s important to understand for a battery to be useful your solar system needs to be generating excess energy for the battery to store, which you can then use at night or when the sun is not out.

When selecting a battery, you’ll want to invest in a system that is most suited to your home and can drive the best return on investment (ROI). Despite a larger upfront cost, a higher quality battery may significantly increase your ROI.

    Battery systems start from $6,000 and costs can vary greatly based on the following factors:

  1. Cycle Life-Time

    The number of times a battery can fully charge and discharge.

  2. Battery Power (kW)

    How fast it can be charged or discharged.

  3. Storage Capacity (kWh)

    The maximum amount of energy a battery system can store.

  4. Battery Management System (BMS)

    An electronic ‘smart’ system that gathers data and manages the battery ensuring it does not overload or operate outside of its safe functioning zone..

  5. Inverter

    Battery systems require their own inverter if your solar system does not have a hybrid inverter.

  6. 'All-In-One Unit’

    A system which includes the battery, BMS and an inverter all in one unit.

  7. Warranty

    Length of time or cycles the battery system is under guarantee.

  8. Blackout Protection/Backup

    It’s important to note this is not a common feature of a battery system and could cost thousands of dollars to include. Blackout protection not only requires additional components but also a specialised installation and rewiring. For grid-connected homes, the cost for blackout protection can outweigh the benefit.

Additionally, if your purpose for adding battery is to go Off-Grid and become completely independent from the grid you will need to ensure your solar system can generate enough energy to power your home and your battery system is large enough to store this energy. For homes in metro areas going Off-grid is not cost effective and is only recommended for those in remote areas with limited access to the grid. Off-grid solar systems with battery start at approximately $30,000.
 

[gravityform id="4"]
<p class="gform_not_found">Oops! We could not locate your form.</p>